The production sound basics I check on every job, from shorts to features. Add yours below. Recording format - 48 kHz, 24-bit, polyphonic Broadcast WAV with every mic on its own iso track plus a mix track. Netflix specifies 24-bit polyphonic WAV at 48 kHz for location dialogue, and most post houses expect the same. - 32-bit float saves you from clipping in the converter and lets you bring levels up or down later without adding noise. It does nothing for a bad mic position, wind, or a capsule that is overloaded before the signal reaches the recorder. - Jam timecode on every recorder and camera at call, and check it again after lunch. Fill in scene, take and track names in the metadata. Your editor will thank you. Mics - Boom first, lavs as safety. Outdoors a shotgun with proper wind protection. Indoors a hypercardioid usually sounds better, because the interference tube of a shotgun picks up early reflections from close walls and turns them into a hollow sound. - Boom as close as the frame line allows, aimed at the mouth, following whoever speaks. Above or below depends on the shot and the shadows. - Lavs: centre of the chest, capsule protected from fabric (tape triangles or a mount), a small loop of cable taped for strain relief. Cotton and wool are quieter than synthetics and silk. On set - Gain: leave headroom for the shout you didn't rehearse. Set the level by hand and keep the limiter as a safety net. - Room tone: 30 to 60 seconds per setup, everyone in place, nobody moving. - Wild lines: if a line was stepped on by a truck or a door, record it right after the take while the actor still has the energy. Delivery loudness (for the mix stage) - Netflix: -27 LKFS dialog-gated, plus or minus 2 LU. - EBU R 128: -23 LUFS integrated programme loudness, true peak at most -1 dBTP. - ATSC A/85 (US broadcast): -24 LKFS. Sources: - Netflix, Live Action Production Sound Best Practices, https://backlothelp.netflix.com/hc/en-us/articles/360000897167-Live-Action-Production-Sound-Best-Practices - Netflix, Sound Mix Specifications and Best Practices, https://backlothelp.netflix.com/hc/en-us/articles/360001794307-Netflix-Sound-Mix-Specifications-Best-Practices-v1-5 - EBU, loudness, https://tech.ebu.ch/loudness - Sound Devices, 32-bit float files explained, https://www.sounddevices.com/32-bit-float-files-explained/
Post side: room tone is the cheapest thing on this list and the one most often skipped. I use it to fill every gap between edited lines, so a scene without tone ends up stitched together from breaths and half-seconds of other takes. Thirty seconds on set saves me an hour.
Actor note on lavs. The best mixers I've worked with tell me what they are about to do before they do it, offer to let me place the mic myself, and make sure wardrobe is there if I want. It takes a minute and it changes how relaxed I am for the whole day. Please also tell us when the mic is live. We forget.
Editor's plea: name the iso tracks in the metadata. Boom, Lav Anna, Lav Ben. When I sync forty takes and the tracks are called Track 1 to Track 6, I can't tell which lav is whose without listening to each one.